Ga door naar hoofdinhoud

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden de handleiding die deze stap bevat.

Stap 3
Once the screen is warm to the touch, apply a suction cup  to the bottom edge of the phone. Pull the suction cup upwards and insert an opening pick in the gap between the display glass and the midframe. Start to cut the adhesive by sliding the opening pick to the bottom right corner. Pull the suction cup upwards and insert an opening pick in the gap between the display glass and the midframe. Start to cut the adhesive by sliding the opening pick to the bottom right corner.
OLED Screen & Digitizer
  • Once the screen is warm to the touch, apply a suction cup to the bottom edge of the phone.

  • Pull the suction cup upwards and insert an opening pick in the gap between the display glass and the midframe. Start to cut the adhesive by sliding the opening pick to the bottom right corner.

Una vez que la pantalla esté caliente al tacto, aplica una ventosa en el borde inferior del teléfono.

Tira de la ventosa hacia arriba e inserta una púa de apertura en el hueco entre el cristal de la pantalla y el marco central. Empieza a cortar el adhesivo deslizando la púa de apertura en la esquina inferior derecha.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.