Ga door naar hoofdinhoud

Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden alle 4 handleidingen die deze stap bevatten.

Engels
Nederlands

Stap 6 vertalen

Stap 6
Rotate the device 180 degrees so that the bottom of the device is facing you. A ribbon connects the battery on the rear cover, to the motherboard.  Slowly lift the bottom of the rear cover up until you can see the ribbon. Use a spudger to push the ribbon away from the motherboard and parallel to the motherboard in order to remove the ribbon.
  • Rotate the device 180 degrees so that the bottom of the device is facing you.

  • A ribbon connects the battery on the rear cover, to the motherboard. Slowly lift the bottom of the rear cover up until you can see the ribbon.

  • Use a spudger to push the ribbon away from the motherboard and parallel to the motherboard in order to remove the ribbon.

  • Separate the rear cover by lifting it up away from the main system.

  • When reassembling the rear cover to the motherboard, reinserting the ribbon cable with a spudger may prove difficult. In this case, gently use your hands to slide the cable end into the slot until they click into place.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.