Ga door naar hoofdinhoud

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 9 handleidingen die deze stap bevatten.

Stap 3
Use a T5 Torx driver to remove the following screws securing the right speaker to the upper case: Two black 6.8 mm screws
  • Use a T5 Torx driver to remove the following screws securing the right speaker to the upper case:

  • Two black 6.8 mm screws

  • One silver 6.3 mm screw

  • The silver screw (in the corner) may be covered with a foam pad. If so, use your tweezers to peel it up and remove it.

Dévissez les vis suivantes, fixant le haut-parleur droit au boîtier supérieur :

Une vis Torx T5 de 6,8 mm

Deux vis Torx T5 de 6,3 mm

Il est possible que la vis dans le coin soit recouverte d'un peu d'éponge métallique. Retirez-la à l'aide d'une pincette ou de la pointe de votre spatule.

[* black] RemoveUse a T5 Torx driver to remove the following screws securing the right speaker to the upper case:
[* red] OneTwo black 6.8 mm T5 Torx screwscrews
[* orange] TwoOne silver 6.3 mm T5 Torx screwsscrew
[* icon_note] The cornersilver screw (in the corner) may be covered with some metallic sponge that should be removed witha foam pad. If so, use your tweezers or the corner of your spudgerto peel it up and remove it.
[* black] RemoveUse a T5 Torx driver to remove the following screws securing the right speaker to the upper case:
[* red] OneTwo black 6.8 mm T5 Torx screwscrews
[* orange] TwoOne silver 6.3 mm T5 Torx screwsscrew
[* icon_note] The cornersilver screw (in the corner) may be covered with some metallic sponge that should be removed witha foam pad. If so, use your tweezers or the corner of your spudgerto peel it up and remove it.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.