Ga door naar hoofdinhoud

Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden alle 4 handleidingen die deze stap bevatten.

Engels
Nederlands
Stap 5
Next, remove the ten 5.92mm T5 torx screws located underneath the kickstand. Remove the seven 5.87mm T5 torx  screws located under the camera casing. There is a sticker covering the second screw from the left.
  • Next, remove the ten 5.92mm T5 torx screws located underneath the kickstand.

  • Remove the seven 5.87mm T5 torx screws located under the camera casing. There is a sticker covering the second screw from the left.

  • Disconnect the rear cover from the main shell of the system by loosening it with a spudger where the gaps exist.

  • There is an electrical ribbon connecting the rear cover to the motherboard. Do not pull apart the rear cover from the motherboard once you have loosened the rear cover from the main system.

  • Continue working your way around to each corner and loosen the snap-ons on each side until the rear cover comes off.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.