Ga door naar hoofdinhoud

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 8 handleidingen die deze stap bevatten.

Stap 2
Apply a suction cup to the heated bottom edge of the back cover. Make sure you did not mistake the screen side for the back cover side. If your back cover is badly cracked, covering it with a layer of clear packing tape may allow the suction cup to adhere.
  • Apply a suction cup to the heated bottom edge of the back cover.

  • Make sure you did not mistake the screen side for the back cover side.

  • If your back cover is badly cracked, covering it with a layer of clear packing tape may allow the suction cup to adhere.

  • Lift on the suction cup with strong, steady force to create a gap.

  • Depending on how aged your phone is, this may take significant force. If you are having trouble, apply more heat and try again.

  • Insert an opening pick into the gap.

  • Don't use metal tools to pry, or you'll mar or shatter the glass back cover. If the panel won't budge, apply more heat, either with a hair dryer or heat gun.

Bringe einen Saugheber am erwärmten unteren Rand der Rückseite an.

Achte darauf, dass der Saugheber wirklich an der Rückseite, nicht irrtümlicherweise auf der Vorderseite befestigt ist.

Wenn die Rückseite sehr zerbrochen ist, dann beklebe sie mit einer Lage Paketband, sodass der Saugheber besser anhaften kann.

Hebe den Saugheber kräftig und gleichmäßig nach oben, bis ein Spalt entsteht.

Je nach Alter des Smartphones kann eine größere Kraft nötig sein. Wenn es schwer geht, dann erwärme nochmals und probiere erneut.

Setze ein Plektrum in den Spalt ein.

[* black] Apply a suction cup to the heated bottom edge of the back cover.
[* icon_caution] Make sure you did not mistake the screen side for the back cover side.
[* icon_note] If your back cover is badly cracked, covering it with a layer of clear packing tape may allow the suction cup to adhere.
[* black] Lift on the suction cup with strong, steady force to create a gap.
[* icon_note] Depending on how aged your phone is, this may take significant force. If you are having trouble, apply more heat and try again.
[* black] Insert an opening pick into the gap.
+ [* icon_caution] Don't use metal tools to pry, or you'll mar or shatter the glass back cover. If the panel won't budge, apply more heat, either with a hair dryer or heat gun.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.