Ga door naar hoofdinhoud

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden de handleiding die deze stap bevat.

Stap 4
Prop up the heated edge of the phone on something that is about 0.5 inches (13 mm) thick. This will angle the phone so that the opening tool is easier to insert. Lift the back cover's right edge with your suction cup, opening a slight gap between the back cover and the frame. This may require a significant amount of force. If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly.
  • Prop up the heated edge of the phone on something that is about 0.5 inches (13 mm) thick. This will angle the phone so that the opening tool is easier to insert.

  • Lift the back cover's right edge with your suction cup, opening a slight gap between the back cover and the frame.

  • This may require a significant amount of force. If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly.

  • If you're using an iOpener, follow the heating instructions to avoid overheating it, or the gel pack may burst.

  • Press the edge of an opening tool into the gap.

  • The rear glass can break if you use too much force or attempt to pry with metal tools.

吸盘吸起手机的加热边缘,厚度约为0.5英寸(13毫米)。这将使手机倾斜,以便撬棒工具更容易插入。

用吸盘提起后盖的右边缘,在后盖和框架之间打开一个小间隙。

这可能需要大量的力量。如果遇到问题,请加热以进一步软化粘合剂,然后再试一次。粘合剂冷却速度非常快,因此你可能需要反复加热。

如果你使用的是iOpener,请按照加热说明操作以避免过热,否则凝胶包可能会破裂。

将撬棒工具的边缘压入间隙。

如果使用过大的力量或试图用金属工具撬动,后玻璃可能会破裂。

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.