Repareer je spullen

Recht op reparatie

Winkel

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 35 handleidingen die deze stap bevatten.

Terug naar de handleiding
Engels
Nederlands
Volgende stap

Stap 1 vertalen

Stap 1
Be very careful to pry evenly on the digitizer connector, and not on the socket at all. The socket and connector are very delicate and if you damage either, your digitizer won't work. To minimize stress on the socket, try prying under the short edge of the connector, rather than the long edge which is shown in these images.

  • Be very careful to pry evenly on the digitizer connector, and not on the socket at all. The socket and connector are very delicate and if you damage either, your digitizer won't work.

  • To minimize stress on the socket, try prying under the short edge of the connector, rather than the long edge which is shown in these images.

  • Gently pry the digitizer connector up from its socket on the logic board.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.