Ga door naar hoofdinhoud
Stap 6
PROCEED WITH CAUTION!!! The antenna cable and the battery contacts are soldered onto the board.
  • PROCEED WITH CAUTION!!! The antenna cable and the battery contacts are soldered onto the board.

  • Your monitor should look like this, with a small gap between the main board and the rear casing.

  • The next step will merely free the volume control dial from the casing and NOT free the main board from the casing.

  • To remove the main board from the casing, you MUST desolder the antenna cable and two battery contacts from the board.

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.