Ga door naar hoofdinhoud

Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden alle 2 handleidingen die deze stap bevatten.

Stap 1 vertalen

Stap 1
Insert the plastic opening tool in the crack in between the cover and the rubber spine with the power button. Pry off the cover, beginning with the side without the volume and bluetooth buttons. When prying the cover off, the six clips (three along each side of rubber spine) that attach the cover to the speaker will make snapping sounds.
  • Insert the plastic opening tool in the crack in between the cover and the rubber spine with the power button.

  • Pry off the cover, beginning with the side without the volume and bluetooth buttons.

  • When prying the cover off, the six clips (three along each side of rubber spine) that attach the cover to the speaker will make snapping sounds.

  • Watch out not to damage the clips on the buttons' side, pry open with caution.

  • Pull the cover off with your thumbs.

プラスチック製オープニングツールをカバーと電源ボタンを含むゴム製突起物の間に差し込みます。

音量ボタンとBluetoothボタンのない方からカバーをこじ開けます。

カバーをこじ開ける際、6つのツメ(3つがゴム製突起物のそれぞれについています)が外れる時にカチッと音がします。

指でカバーを引き離します。

[* black] Insert the plastic opening tool in the crack in between the cover and the rubber spine with the power button.
[* black] Pry off the cover, beginning with the side without the volume and bluetooth buttons.
[* icon_note] When prying the cover off, the six clips (three along each side of rubber spine) that attach the cover to the speaker will make snapping sounds.
+[* icon_caution] Watch out not to damage the clips on the buttons' side, pry open with caution.
[* black] Pull the cover off with your thumbs.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.