Ga door naar hoofdinhoud

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 7 handleidingen die deze stap bevatten.

Stap 8
The top edge of the display is secured with both glue and clips. Slide the opening pick around the top corner of the display, while gently pulling or wiggling the display down in the direction of the Lightning port. The clips will break if you use too much force. Work carefully and be patient.
  • The top edge of the display is secured with both glue and clips.

  • Slide the opening pick around the top corner of the display, while gently pulling or wiggling the display down in the direction of the Lightning port.

  • The clips will break if you use too much force. Work carefully and be patient.

  • Again, don't insert the pick more than a few millimeters—about the width of the display bezel—or you may damage the front panel sensor array.

  • Slide the pick to the opposite corner and cut any remaining adhesive securing the display.

显示器的顶部边缘被胶水和夹子固定。

将开口拨片滑动到显示屏的顶角,同时 沿着Lightning端口的方向 轻轻拉动或摆动显示屏。

如果你用力太大,夹子可能会破裂。 请小心并谨慎操作。

需要强调的是,不要将开口拨片插入超过显示器挡板宽度的几毫米 - 否则可能会损坏前面板传感器阵列。

将开口拨片滑到对角,并清理固定显示器的任何剩余粘合剂。

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.