Repareer je spullen Gemeenschap Winkel

Sostituzione gruppo cavo antenna del MacBook Pro 13" Touch Bar versione fine 2016

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 4 handleidingen die deze stap bevatten.

Terug naar de handleiding
Engels
Italiaans
Stap 7
MacBook Pro 13" Touch Bar Late 2016 Antenna Cable Assembly Replacement: stap 0, afbeelding 1 van 3 MacBook Pro 13" Touch Bar Late 2016 Antenna Cable Assembly Replacement: stap 0, afbeelding 2 van 3 MacBook Pro 13" Touch Bar Late 2016 Antenna Cable Assembly Replacement: stap 0, afbeelding 3 van 3

  • Carefully disconnect the three antenna coax cables by prying them straight up from the logic board.

  • Slide your tweezers or the flat end of your spudger underneath each cable until it's near the socket, and then gently twist or pry up to disconnect it.

  • To reconnect each cable, align the connector directly over its socket, and then press down so it snaps into place.

Disconnetti con cautela i due cavi coassiali di antenna alzandoli in verticale dalla scheda logica.

Fai scorrere le pinzette o lo spudger sotto ciascun cavo finché non arrivi vicino allo zoccolo e a quel punto torci l'attrezzo o fai leva per scollegare il connettore.

Per riconnettere ciascun cavo, allinea il connettore sopra il suo zoccolo e quindi premilo verso il basso finché non scatta in posizione.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.