Ga door naar hoofdinhoud

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 8 handleidingen die deze stap bevatten.

Stap 1 vertalen

Stap 1
Heat an iOpener and apply it to the top edge of the display for two minutes. A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the display and internal battery are both susceptible to heat damage. Take note of the following regions before you begin prying:
  • Heat an iOpener and apply it to the top edge of the display for two minutes.

  • A hair dryer, heat gun, or hot plate may also be used, but be careful not to overheat the phone—the display and internal battery are both susceptible to heat damage.

  • Take note of the following regions before you begin prying:

  • Thin adhesive lined against the display panel

  • Thick adhesive

  • The OLED display panel, which is very prone to damage

  • The display cable, which can be damaged during prying

加热iOpener并将其覆盖在显示屏的左边缘两分钟。

您也可以使用吹风机、热风枪或电热板,但要注意不要使手机过热 - 显示器和电池都易受过热损坏。

在开始撬动屏幕前记下这些有粘合剂的区域:

屏幕边缘的狭长的粘合剂带

屏幕上下的大面积粘合剂

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.