Inleiding

The camera is attached to the motherboard in your phone. A T6 screwdriver is needed to access the camera.

Onderdelen

Geen onderdelen nodig.

Press down the button on the back panel.
  • Press down the button on the back panel.

Voeg opmerking toe

Push the back cover upwards. Push the back cover upwards.
  • Push the back cover upwards.

Voeg opmerking toe

Remove the back cover from the phone. Remove the back cover from the phone.
  • Remove the back cover from the phone.

Voeg opmerking toe

Press the silver button on the top of the phone.
  • Press the silver button on the top of the phone.

Voeg opmerking toe

Pull the top of the case apart.
  • Pull the top of the case apart.

  • Slide thumbnail down the case seam to separate the rest of the case.

Voeg opmerking toe

Gently pull the case apart.
  • Gently pull the case apart.

  • Careful! Do not to bend the plastic tabs.

Voeg opmerking toe

Using a T6 Torx Screwdriver, unscrew and remove the six screws shown in the picture. Using a T6 Torx Screwdriver, unscrew and remove the six screws shown in the picture.
  • Using a T6 Torx Screwdriver, unscrew and remove the six screws shown in the picture.

Voeg opmerking toe

Remove the panel that covers the motherboard. If replacing the speaker, stop at this step and skip forward to the first step of the speaker guide.
  • Remove the panel that covers the motherboard.

  • If replacing the speaker, stop at this step and skip forward to the first step of the speaker guide.

Voeg opmerking toe

Remove the LCD screen frame.
  • Remove the LCD screen frame.

Voeg opmerking toe

Remove the motherboard.
  • Remove the motherboard.

Voeg opmerking toe

Locate the camera on the circuit board.
  • Locate the camera on the circuit board.

Voeg opmerking toe

Place the circuit board on a firm, static free surface (no cloth/carpet).
  • Place the circuit board on a firm, static free surface (no cloth/carpet).

  • NOTE: The circled alignment notch points to the left.

Voeg opmerking toe

Pull the left holding tabs to the left.
  • Pull the left holding tabs to the left.

Voeg opmerking toe

Lift out the left side of the camera.
  • Lift out the left side of the camera.

Voeg opmerking toe

Pull the right holding tabs to the right.
  • Pull the right holding tabs to the right.

Voeg opmerking toe

Pull camera off of board.
  • Pull camera off of board.

Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

2 andere personen hebben deze handleiding voltooid.

Job Jao

Lid sinds: 08-10-10

37 reputatie

2 handleidingen geschreven

Team

Cal Poly, Team 3-27, Regan Fall 2010 Lid van Cal Poly, Team 3-27, Regan Fall 2010

CPSU-REGAN-F10S3G27

4 Leden

9 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 1

Altijd: 1,748