Ga door naar hoofdinhoud

Inleiding

This guide will help you in identifying the soldering joints locations for the loud speaker on the iPod Touch 4th Generation

  1. I've boxed where the ribbon cable connectors go for the screen and camera. The soldering joints are marked with a Blue and a Red dot to indicate where to solder the speaker wires.
    • I've boxed where the ribbon cable connectors go for the screen and camera.

    • The soldering joints are marked with a Blue and a Red dot to indicate where to solder the speaker wires.

    • The second picture shows the wires soldered to the logic board.

    • The loud speaker replacement was very tedious job.. anyways Good Luck

Conclusie

To reassemble your device, follow these instructions in reverse order.

3 andere personen hebben deze handleiding voltooid.

Tysl332

Lid sinds: 11-02-14

289 Reputatie

1 Handleiding geschreven

0 Opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 2

Afgelopen 30 dagen: 9

Altijd: 6,316