Ga door naar hoofdinhoud

Deze handleiding heeft recentere wijzigingen. Schakel over naar de nieuwste niet-geverifieerde versie.

iPhone 4 Speaker Enclosure Assembly Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. iPhone 4 Speaker Enclosure Assembly Replacement, Speaker Enclosure Assembly: stap 1, afbeelding 1 van 2 iPhone 4 Speaker Enclosure Assembly Replacement, Speaker Enclosure Assembly: stap 1, afbeelding 2 van 2
    • Remove the following two screws:

    • One 1.2 mm Phillips

    • One 1.6 mm Phillips

    • Remove the thin steel dock connector cable cover from the iPhone.

    • Before reassembly, be sure to clean all metal-to-metal contact points on the dock connector cable cover with a de-greaser such as windex. The oils on your fingers have the potential to cause wireless interference issues.

  2. iPhone 4 Speaker Enclosure Assembly Replacement: stap 2, afbeelding 1 van 2 iPhone 4 Speaker Enclosure Assembly Replacement: stap 2, afbeelding 2 van 2
    • Use a plastic opening tool to gently pry the dock cable connector up off the logic board from both short ends of the connector.

  3. iPhone 4 Speaker Enclosure Assembly Replacement: stap 3, afbeelding 1 van 2 iPhone 4 Speaker Enclosure Assembly Replacement: stap 3, afbeelding 2 van 2
    • Carefully peel the dock ribbon cable off the logic board and the lower speaker enclosure.

    • Do not use excessive force to peel the dock ribbon cable off the logic board. Doing so may tear the cable.

  4. iPhone 4 Speaker Enclosure Assembly Replacement: stap 4, afbeelding 1 van 1
    • Use a plastic opening tool to pry the lower antenna connector up off its socket on the logic board.

  5. iPhone 4 Speaker Enclosure Assembly Replacement: stap 5, afbeelding 1 van 1
    • Remove the following screws securing the speaker enclosure assembly to the outer case:

    • One 1.9 mm Phillips screw

    • One 2.4 mm Phillips screw

  6. iPhone 4 Speaker Enclosure Assembly Replacement: stap 6, afbeelding 1 van 3 iPhone 4 Speaker Enclosure Assembly Replacement: stap 6, afbeelding 2 van 3 iPhone 4 Speaker Enclosure Assembly Replacement: stap 6, afbeelding 3 van 3
    • Use a plastic opening tool to lift the speaker enclosure assembly out of the case, being sure not to damage the EMI fingers on the attached Wi-Fi antenna.

    • Remove the speaker enclosure assembly.

    • Before reinstalling the speaker enclosure assembly's screws, be sure the Wi-Fi grounding fingers are installed below the lip in the iPhone's metal case as seen in the third picture.

    • Before reassembly, be sure to clean all metal-to-metal contact points between the grounding fingers of the Wi-Fi antenna and the case of the iPhone with a de-greaser such as windex or isopropyl alcohol. The oils on your fingers have the potential to cause wireless interference issues.

Conclusie

To reassemble your device, follow these instructions in reverse order.

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 59