Ga door naar hoofdinhoud

Inleiding

Prerequisite only guide for removing the front panel assembly from an iPad Mini 3.

Onderdelen

Geen onderdelen opgegeven.

  1. Use the tip of a spudger to lift the digitizer cable connector straight up off of its socket. Use the tip of a spudger to lift the digitizer cable connector straight up off of its socket.
    • Use the tip of a spudger to lift the digitizer cable connector straight up off of its socket.

  2. Slide the flat end of a spudger under the battery side of the digitizer board to begin separating it from the rear case. Slide the flat end of a spudger under the battery side of the digitizer board to begin separating it from the rear case.
    • Slide the flat end of a spudger under the battery side of the digitizer board to begin separating it from the rear case.

  3. Lift the digitizer board up to free the last of the adhesive. Lift the digitizer board up to free the last of the adhesive.
    • Lift the digitizer board up to free the last of the adhesive.

  4. Lift and remove the front panel assembly from the iPad.
    • Lift and remove the front panel assembly from the iPad.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Evan Noronha

Lid sinds: 05-02-15

207.659 Reputatie

178 handleidingen geschreven

Team

iFixit Lid van iFixit

Community

138 Leden

16.477 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 186