Ga door naar hoofdinhoud

iPad 4 CDMA Home Button Control Board Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. iPad 4 CDMA Home Button Control Board Replacement, Home Button Control Board: stap 1, afbeelding 1 van 1
    • Remove the two 2.1 mm Phillips #00 Phillips screws securing the home button control board to the home button mounting bracket.

  2. iPad 4 CDMA Home Button Control Board Replacement: stap 2, afbeelding 1 van 2 iPad 4 CDMA Home Button Control Board Replacement: stap 2, afbeelding 2 van 2
    • Wedge the flat edge of a plastic opening tool in between the right end of the home button control board and the home button mounting bracket.

    • Depress the plastic opening tool downwards to pry the adhesive securing the home button control board from the home button mounting bracket.

    • Repeat the procedure to release the adhesive underneath the left end of the home button control board.

  3. iPad 4 CDMA Home Button Control Board Replacement: stap 3, afbeelding 1 van 1
    • Lift and remove the home button control board up off the home button mounting bracket.

  4. iPad 4 CDMA Home Button Control Board Replacement: stap 4, afbeelding 1 van 2 iPad 4 CDMA Home Button Control Board Replacement: stap 4, afbeelding 2 van 2
    • Use the flat edge of a spudger to scrape the old adhesive off the bottom right corner of the front panel assembly.

    • If necessary, gently peel the old adhesive with a pair of tweezers.

  5. iPad 4 CDMA Home Button Control Board Replacement: stap 5, afbeelding 1 van 2 iPad 4 CDMA Home Button Control Board Replacement: stap 5, afbeelding 2 van 2
    • Gently place the home button control board on top of the home button mounting bracket.

    • Make sure the home button control board is lined up with the bottom of the home button mounting bracket.

  6. iPad 4 CDMA Home Button Control Board Replacement: stap 6, afbeelding 1 van 1
    • Insert the two 2.1 mm Phillips #00 Phillips screws back into the home button control board to secure it against the home button mounting bracket.

Conclusie

To reassemble your device, follow these instructions in reverse order.

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 137