Ga door naar hoofdinhoud

iPad 3 4G Antenna Connectors Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. iPad 3 4G Antenna Connectors Replacement, Antenna Connectors: stap 1, afbeelding 1 van 1
    • Remove the seven screws securing the logic board to the rear aluminum panel.

    • Six 2.1mm Phillips #00

    • One 2.5mm Phillips #00

  2. iPad 3 4G Antenna Connectors Replacement: stap 2, afbeelding 1 van 1
    • Flip the logic board over, minding any cables that may get caught.

    • Using the tip of a spudger, remove the three antenna connectors from their sockets on the logic board.

    I know the middle connector goes to the left antenna. Where do the other two go?

    Anticept - Antwoord

    Looking this pic, the left cable goes to the right antena and the right one to the middle antena (or whatever is there) under the front camera

    Maratech - Antwoord

    Right antenna, left antenna, GPS

    Malcolm Stevens - Antwoord

Conclusie

To reassemble your device, follow these instructions in reverse order.

Brett Hartt

Lid sinds: 04/12/10

127.749 Reputatie

143 handleidingen geschreven

Team

iFixit Lid van iFixit

Staff

136 Leden

16.573 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 65