Ga door naar hoofdinhoud

Inleiding

Removing LCD assembly with front panel attached. Internal Prerequisite.

Onderdelen

Geen onderdelen opgegeven.

  1. Remove the four 2.0 mm Phillips screws securing the LCD to the rear case.
    • Remove the four 2.0 mm Phillips screws securing the LCD to the rear case.

  2. Lift the LCD from its long edge closest to the volume buttons and rotate it out of the rear case. Lay the LCD on the front panel as seen in the second picture.
    • Lift the LCD from its long edge closest to the volume buttons and rotate it out of the rear case.

    • Lay the LCD on the front panel as seen in the second picture.

  3. Use the edge of a plastic opening tool to flip up the metal retaining clip securing the display data cable to its socket on the logic board.
    • Use the edge of a plastic opening tool to flip up the metal retaining clip securing the display data cable to its socket on the logic board.

  4. Pull the display data cable out of its socket on the logic board.
    • Pull the display data cable out of its socket on the logic board.

    • Do not lift upward on the display data cable connector as you disconnect it.

  5. Remove the LCD assembly from the iPad 2.
    • Remove the LCD assembly from the iPad 2.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Één andere persoon heeft deze handleiding voltooid.

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 307