Ga door naar hoofdinhoud

iMac Intel 24" EMC 2134 and 2211 Hard Drive Replacement

Alleen vereisten
Deze handleiding is alleen bedoeld als vereiste voor andere handleidingen. Het staat niet op zichzelf.

Wat je nodig hebt

  1. iMac Intel 24" EMC 2134 and 2211 Hard Drive Replacement, Hard Drive: stap 1, afbeelding 1 van 1
    • If necessary, remove the pieces of tape securing the hard drive/optical drive thermal sensor cables to your iMac.

  2. iMac Intel 24" EMC 2134 and 2211 Hard Drive Replacement: stap 2, afbeelding 1 van 1
    • Disconnect the hard drive thermal sensor by pulling its connector upwards toward the top of your iMac.

    • When removing this connector, it is helpful use your thumbnails to push the ears on either side of the connector toward the top of your iMac.

  3. iMac Intel 24" EMC 2134 and 2211 Hard Drive Replacement: stap 3, afbeelding 1 van 2 iMac Intel 24" EMC 2134 and 2211 Hard Drive Replacement: stap 3, afbeelding 2 van 2
    • Pressing the top of the hard drive bracket down to release it from the rear case requires a substantial amount of force. We recommend laying your iMac stand-side down on a table to avoid knocking it over.

    • Press the hard drive bracket down toward the bottom edge of your iMac to free it from the rear case, then rotate the top of the drive toward yourself.

  4. iMac Intel 24" EMC 2134 and 2211 Hard Drive Replacement: stap 4, afbeelding 1 van 2 iMac Intel 24" EMC 2134 and 2211 Hard Drive Replacement: stap 4, afbeelding 2 van 2
    • Rotate the hard drive toward yourself, then lift it up off its mounting pins.

    • The hard drive is still connected via the SATA cables.

    • When reinstalling your hard drive, be careful not to push the rubber grommets through the openings in the chassis with the lower hard drive pins as retrieving them may require logic board removal.

  5. iMac Intel 24" EMC 2134 and 2211 Hard Drive Replacement: stap 5, afbeelding 1 van 1
    • Insert the flat end of a spudger between the SATA power cable connector and the edge of the hard drive.

    • Twist the spudger to separate the connector from the hard drive.

  6. iMac Intel 24" EMC 2134 and 2211 Hard Drive Replacement: stap 6, afbeelding 1 van 1
    • Pull the SATA power connector away from the hard drive.

  7. iMac Intel 24" EMC 2134 and 2211 Hard Drive Replacement: stap 7, afbeelding 1 van 1
    • Disconnect the SATA data cable by pulling its connector away from the hard drive.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Brittany McCrigler

Lid sinds: 03/05/12

89.011 Reputatie

131 handleidingen geschreven

Team

iFixit Lid van iFixit

Staff

135 Leden

16.732 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 625