Ga door naar hoofdinhoud

Inleiding

Internal Prerequisite.

  1. Disconnect the SATA data and power cables by pulling their connectors away from the hard drive. Disconnect the SATA data and power cables by pulling their connectors away from the hard drive.
    • Disconnect the SATA data and power cables by pulling their connectors away from the hard drive.

  2. Disconnect the hard drive thermal sensor cable from the thermal sensor attached to the side of the hard drive.
    • Disconnect the hard drive thermal sensor cable from the thermal sensor attached to the side of the hard drive.

    Since you're going to transfer this to the new drive, I found it easier to disconnect the other end of the temp sensor cable, on the edge of the mobo.

    maccentric - Antwoord

    Agree 100% with maccentric. Disconnecting the other end of the temp sensor cable is a much easier way to go on this step.

    phil - Antwoord

  3. iPhone Batterij Fix Kits

    Slechts $29.99

    Buy Now

    iPhone Batterij Fix Kits

    Slechts $29.99

    Buy Now
  4. Compress the plastic hard drive retainer by pushing it toward the bottom edge of the iMac. Pull the top edge of the hard drive slightly away from the rear case.
    • Compress the plastic hard drive retainer by pushing it toward the bottom edge of the iMac.

    • Pull the top edge of the hard drive slightly away from the rear case.

    I found it easier to take out the two torq screws on the plastic holder, in stead of compressing it.

    eriktar - Antwoord

  5. Lift the hard drive off its bottom retaining posts and remove it from the iMac.
    • Lift the hard drive off its bottom retaining posts and remove it from the iMac.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 250