Inleiding

The fan duct directs air across the heat sink on the logic board.

  1. Lay the iMac display-side down on a flat surface.
    • Lay the iMac display-side down on a flat surface.

    • Loosen the three Phillips screws securing the rear panel to the iMac.

    • These screws are captive in the iMac. The center screw will stop turning after about 3.5 turns and the outer screws will stop turning after about 5.5 turns. Do not try to remove these screws from your iMac.

  2. Lift the rear panel slightly near the bottom of the iMac. Pull the rear panel toward yourself and remove it from the iMac.
    • Lift the rear panel slightly near the bottom of the iMac.

    • Pull the rear panel toward yourself and remove it from the iMac.

  3. Gratis verzending van alle bestellingen van meer dan US$ 100,00 of met een Pro Tech Toolkit!

    Doorblader onze winkel
  4. Remove the following two screws:
    • Remove the following two screws:

      • One 11 mm T10 Torx.

      • One 10.6 mm T8 Torx.

  5. Lift the fan duct out of the chassis.
    • Lift the fan duct out of the chassis.

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 6

Altijd: 8,692