Deze handleiding heeft recentere wijzigingen. Schakel over naar de nieuwste niet-geverifieerde versie.
Inleiding
Use this guide to replace the monster 20" LCD housed within your iMac.
Wat je nodig hebt
-
-
Lay the iMac display-side down on a flat surface.
-
Loosen the three Phillips screws securing the rear panel to the iMac.
-
-
-
Rotate each of the two RAM retaining arms away from the RAM chip.
-
Pull the RAM chip straight away from its socket.
-
-
-
Remove the following three screws securing the inverter to the chassis:
-
Two 7.9 mm Phillips.
-
One 26 mm Phillips.
-
-
-
-
Remove the four 7 mm Phillips screws securing the optical drive to the midplane.
-
-
-
Remove the two 7.3 mm shouldered Phillips screws securing the display cable connector to the logic board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Annuleren: ik heb deze handleiding niet afgemaakt.
18 andere personen hebben deze handleiding voltooid.
2 opmerkingen
Excellent Thank you
Very detailed. Thank you.
Some models (with light sensor) have only the two outboard screws.
Robert Huber - Antwoord