Menu

Jouw instellingen

Mijn werkbank

Krijg snel toegang tot handleidingen, onderdelen en antwoorden voor jouw apparaten
Winkelwagen

Het lijkt erop dat je mandje leeg is

Doorblader onze winkel

iMac G5 17" Model A1144 Hard Drive Replacement

Geschreven door: Walter Galan (en 3 andere bijdragers)
  • Reacties: 0
  • Favorieten: 0

Moeilijkheid

Gemiddeld

Stappen

4

Tijd vereist

Stel een tijd voor??

Secties

1

Markeringen

1

Prerequisite Only

Alleen vereisten

Houd er rekening mee dat dit slechts een vereiste handleiding is voor andere handleidingen.

Gereedschap

Koop deze gereedschappen

Onderdelen

Geen onderdelen opgegeven.

  1. Disconnect the hard drive thermal sensor by pulling the connector away from its socket parallel to the face of the hard drive.

    • Disconnect the hard drive thermal sensor by pulling the connector away from its socket parallel to the face of the hard drive.

    Bewerken

  2. Pressing the top of the hard drive bracket down to release it from the rear case requires a substantial amount of force, so we recommend laying your iMac stand-side down on a table to avoid knocking it over. Press the hard drive bracket down toward the bottom edge of your iMac to free it from the rear case, then rotate the top of the drive toward yourself.

    • Pressing the top of the hard drive bracket down to release it from the rear case requires a substantial amount of force, so we recommend laying your iMac stand-side down on a table to avoid knocking it over.

    • Press the hard drive bracket down toward the bottom edge of your iMac to free it from the rear case, then rotate the top of the drive toward yourself.

    • Lift the hard drive off its lower pins and pull it out of the rear case, minding the cables that are still attached.

    • When reinstalling the hard drive, be careful not to push the rubber grommets through the chassis with the hard drive pins as retrieving them may require logic board removal.

    Bewerken

  3. iPhone X Fix Kits

    Warranty up? No worries, we’ve got the fix.

    Nu winkelen

    iPhone X Fix Kits

    Warranty up? No worries, we’ve got the fix.

    Nu winkelen

  4. Insert the flat end of a spudger into the gap between the SATA power connector and the hard drive. Twist the spudger to separate the SATA power connector from the hard drive.

    • Insert the flat end of a spudger into the gap between the SATA power connector and the hard drive.

    • Twist the spudger to separate the SATA power connector from the hard drive.

    • Pull the SATA power connector away from the hard drive.

    Bewerken

  5. Pull the SATA data cable away from the hard drive.

    • Pull the SATA data cable away from the hard drive.

    • Hard drive remains.

    Bewerken
Conclusie

To reassemble your device, follow these instructions in reverse order.

0 Opmerkingen

Een opmerking toevoegen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 0

Afgelopen 30 Dagen: 0

Altijd: 532