Ga door naar hoofdinhoud

Inleiding

Use this guide to remove your iHome iP1's back cover. This cover is located on the underside of the platorm connecting the speakers. Although it serves no function other than to protect the motherboard, it is necessary to remove in order to remove many other components of the iHome iP1, such as the speakers and the 30-pin connector.

Onderdelen

Geen onderdelen opgegeven.

  1. Orient the iHome upside down with the speakers facing away from you.
    • Orient the iHome upside down with the speakers facing away from you.

  2. Remove the four 9.5 mm Phillips #2 screws located on each of the four corners of the iHome's back cover. Remove the four 9.5 mm Phillips #2 screws located on each of the four corners of the iHome's back cover.
    • Remove the four 9.5 mm Phillips #2 screws located on each of the four corners of the iHome's back cover.

  3. Remove the back cover by grabbing its sides and lifting it off the iHome.
    • Remove the back cover by grabbing its sides and lifting it off the iHome.

Conclusie

To reassemble your device, follow these instructions in reverse order.

Wen Sullivan

Lid sinds: 06-10-16

476 Reputatie

4 handleidingen geschreven

Team

Cal Poly, Team 20-1, Livingston Fall 2016 Lid van Cal Poly, Team 20-1, Livingston Fall 2016

CPSU-LIVINGSTON-F16S20G1

4 Leden

7 handleidingen geschreven

0 Opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 0

Afgelopen 7 dagen: 0

Afgelopen 30 dagen: 0

Altijd: 139