Inleiding

One RAM slot will accept PC2100 or PC2700 chips up to 1 GB.

  1. Use a coin to rotate the battery locking screw 90 degrees clockwise.
    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

    Voeg opmerking toe

  2. Lift the battery out of the computer.
    • Lift the battery out of the computer.

    Voeg opmerking toe

    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

    Voeg opmerking toe

    • If the computer has an AirPort card installed, follow the next three steps to remove it.

    • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

    Voeg opmerking toe

  3. Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    Verspreid de kerstsfeer
    Krijg 12€ korting op je aankoop van 50€ of meer met de code FIXMAS12
    • Grasp the clear plastic tab on the AirPort card and pull toward the display.

    Voeg opmerking toe

    • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

    Voeg opmerking toe

    • Remove the four silver Phillips screws that secure the RAM shield.

    Voeg opmerking toe

    • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

    Voeg opmerking toe

    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

    Voeg opmerking toe

    • Release the tabs on each side of the RAM chip at the same time. These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

    Voeg opmerking toe

    • Pull the chip directly out from its connectors.

    Voeg opmerking toe

Conclusie

To reassemble your device, follow these instructions in reverse order.

32 andere personen hebben deze handleiding voltooid.

Bijgevoegde documenten

iRobot

Lid sinds: 24-09-09

1 Reputatie

623 handleidingen geschreven

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 Uren: 0

Afgelopen 7 Dagen: 1

Afgelopen 30 Dagen: 8

Altijd: 35,533