Ga door naar hoofdinhoud

iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement

Wat je nodig hebt

  1. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement, Battery: stap 1, afbeelding 1 van 1
    • Use a coin to rotate the battery locking screw 90 degrees clockwise.

  2. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: stap 2, afbeelding 1 van 1
    • Lift the battery out of the computer.

  3. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement, Keyboard: stap 3, afbeelding 1 van 1
    • Pull the keyboard release tabs toward you and lift up on the keyboard until it pops free.

    • If the keyboard does not come free, use a small flathead screwdriver to turn the keyboard locking screw 180 degrees in either direction and try again. The locking screw is in between the F5 and F6 keys and is a clear piece of plastic.

    • Flip the keyboard over, away from the screen, and rest it face-down on the trackpad area.

  4. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: stap 4, afbeelding 1 van 1
    • If the computer has an AirPort card installed, follow the next three steps to remove it.

    • Push the wire clasp away from the AirPort card and toward the display, then rotate up to free it from the RAM shield.

  5. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: stap 5, afbeelding 1 van 1
    • Grasp the clear plastic tab on the AirPort card and pull toward the display.

  6. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: stap 6, afbeelding 1 van 1
    • Hold the AirPort card in one hand and use your other hand to remove the antenna cable.

  7. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: stap 7, afbeelding 1 van 1
    • Remove the four silver Phillips screws that secure the RAM shield.

  8. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: stap 8, afbeelding 1 van 1
    • Grasp the metal bracket on top of the RAM shield and pull upward to remove the shield.

  9. iBook G4 14" 933 MHz-1.33 GHz Keyboard Replacement: stap 9, afbeelding 1 van 1
    • Pull the keyboard cable up from the logic board, holding the cable as close to the connector as possible.

    • Make sure that you reconnect the keyboard cable before replacing the RAM shield.

Conclusie

To reassemble your device, follow these instructions in reverse order.

4 andere personen hebben deze handleiding voltooid.

Bijgevoegde documenten

iRobot

Lid sinds: 09/24/09

1 Reputatie

636 handleidingen geschreven

0 opmerkingen

Voeg opmerking toe

Weergavestatistieken:

Afgelopen 24 uren: 1

Afgelopen 7 dagen: 3

Afgelopen 30 dagen: 12

Altijd: 12,216