Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Help
Bewerken van stap 3 —

Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden alle 5 handleidingen die deze stap bevatten.

Stap type:

Sleep om te herschikken

Secure a suction cup to the back cover, as close to the heated edge as possible.

The suction cup will not make a good seal on the curved portion of the glass, so avoid putting it on the very edge.

If the phone's back cover is cracked, the suction cup may not stick. Try lifting it with strong tape, or superglue the suction cup in place and allow it to cure so you can proceed.

Lift the back cover's left edge with your suction cup, opening a slight gap between the back cover and the frame.

This may require a significant amount of force, but you only need to open a very slight gap with the suction cup to insert your tool.

If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly.

If you're using an iOpener, follow instructions to avoid overheating it, or the gel pack may burst.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.