Ga door naar hoofdinhoud
Help

Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden alle 4 handleidingen die deze stap bevatten.

Stap type:

Sleep om te herschikken

Whether installing a replacement display assembly or re-using the existing display assembly, note the following:

Carefully straighten the digitizer and LCD data cables, and feed them through the slot cut in the outer case.

The middle photo shows the digitizer cable being correctly fed through to its full length.

This photo shows the display assembly being installed incorrectly, with too much slack in the digitizer cable, which then forms a bend/loop that gets caught in the slot. The third photo also shows this loop.

If the digitizer cable has been installed incorrectly, it will not reach its socket on the logic board. Do not attempt to pull it through by force, or it will be cut by the sharp edge of its slot in the enclosure. Remove the display assembly, straighten the cable, and re-feed the cable through completely and correctly.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.