Ga door naar hoofdinhoud

Fix Your Stuff

Right to Repair

Parts & Tools

Bewerken van stap 7 —

Stap type:

Sleep om te herschikken

Use the same method above to solder the second resistor lead to the circuit board.

After soldering a joint, if you are going to put the soldering iron down, be sure to place it back in its stand to prevent burning yourself or anything around you.

Cut the extra lengths of the resistor leads with a pair of wire cutters. NASA workmanship standards state that any length up to 2.29 mm is acceptable.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.