Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie


Bewerken van stap 9 —

Stap type:

Sleep om te herschikken

Pretty much any switch will work here. I used a small enclosure by BUD Industries (from Mouser)

I made 2 holes in some perf board for a couple of tact switches. They have a nice feel to them.

I've ordered a prototype PCB for this enclosure from BatchPCB and will make it available on their market place once I verify that it works.

Update: You can now get a PCB for the enclosure for 5.00$ There is a 10$ per order set up charge from them so you might also want to order the connector PCB at the same time.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.