Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie


Bewerken van stap 5 —

Stap type:

Sleep om te herschikken

The next step will be to make the edge connector out of a scrap piece of PCB.

I chose a section with ground plane on at least one side. It was sanded down to fit and scored to make 4 'traces'.

The size of the traces almost matches a PCI connector. You might be able to scavenge a section from an old card. However, the traces leading away from the edge must travel straight together for a while so you have enough room for the cable for connect to them.

I've ordered a prototype connector from BatchPCB and will make it available on their market place once I verify that it works.

Update: You can now get the connector here from BatchPCB. It's $2.50 but there is a $10 per order set up charge from them so you might also want to order the PCB for the switch at the same time.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.