Ga door naar hoofdinhoud
Bewerken van stap 4 —

Stap type:

Sleep om te herschikken

Here is the external connector to be rewired. It's attached with 4 #00 JIS screws and is not soldered to the pads on the logic board.

Rather than cutting traces and connecting directly to the pads, I covered them with a piece of Kapton and made new 'pads' with two strips of copper tape. There is a little IC that you will need to run over, but this step is very easy (and reversible).

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.