Skip to main content
Help
Bewerken van stap 12 —

Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden alle 11 handleidingen die deze stap bevatten.

Stap type:

Sleep om te herschikken

Remove the 4.8 mm standoff screw near the headphone jack.

Standoff screws are best removed using an iPhone Standoff Screwdriver Bit and driver handle.

In a pinch, a small flathead screwdriver will do the job—but use extra caution to ensure it doesn't slip and damage surrounding components.

When reassembling the device, this standoff sets the height of the Wi-Fi shield removed in step 13. If not torqued down, the shield will be above the plane of the frame and the back will not slide into place in step 2. The shield should be flush with the headphone jack.

When reassembling the motherboard, ensure that its edge sits under the circled standoff, otherwise the screws will not fit.

When reassembling ensure that the small rubber spacer attached to the top of the motherboard is in place.

Without this part, the motherboard could damage the ribbon cables around it.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.