Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Help
Bewerken van stap 19 —

Stap type:

Sleep om te herschikken

With the heatsink bracket removed the DMD board can be removed from the rear cover.

It can help to start removing the board by pulling out on the upper right edge.

Then, pull on the right side of the board.

The board should then pivot out from the right. It is a snug fit but it should remove with care.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.