Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Help
Bewerken van stap 18 —

Stap type:

Sleep om te herschikken

With the DMD board exposed, proceed to remove the four screws that hold the heatsink bracket to the board.

DO NOT touch the screws highlighted in red.

These three screws highlighted in red are for adjustment of the DLP chip/DMD board. If you touch them you will throw off the factory adjustment of your chip.

With the four screws highlighted in green removed you can remove the heatsink bracket.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.