Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Help
Bewerken van stap 11 —

Stap type:

Sleep om te herschikken

Next, proceed by removing all of the cables that connect to the DMD board.

At the upper right edge there is a small ribbon cable that pulls straight up to remove, and two other cables that connect with cable ends that clip in to the small plugs. Remove these three cables carefully.

Next, remove the three cables on the right end of the DMD board. The two upper are fan power cables, and the lower connects to the light bulb controls.

Finally, remove the lower most cable that connects to the bottom left corner of the DMD board.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.