Ga door naar hoofdinhoud
Help
Bewerken van stap 4 —

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 8 handleidingen die deze stap bevatten.

Stap type:

Sleep om te herschikken

Remove the front panel assembly.

If the home button ribbon cable sticks to the iPad's rear case, don't try to force it. Gently peel it off the case using a pair of tweezers, and then you can fully remove the front panel assembly.

If you experience "ghost" or "phantom" touch input issues with your new display, this can be resolved by adding a layer of very thin insulating tape, such as Kapton (polyimide) tape, to the highlighted areas on the back of the panel. iFixit panels come with the proper insulation, and should not require the addition of any tape.

Without the proper insulation, these areas of the digitizer can ground out against other components, causing touch input malfunction.

The insulation is not visible to the naked eye, and is different from the foam dust barrier strips found on many iPads.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.