Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Bewerken van stap 10 —

Stap type:

Sleep om te herschikken

Switch on your multimeter, and set the dial to DC voltage mode (indicated by a V with a straight line, or the symbol ⎓).

Virtually all consumer electronic devices run on DC voltage. AC voltage—the kind that runs through the lines to your house—is considerably more dangerous, and beyond the scope of this guide.

Most multimeters are not autoranging, meaning you will need to set the correct range for the voltage you expect to measure.

Each setting on the dial lists the maximum voltage it can measure. So for example, if you expect to measure more than 2 volts but less than 20, use the 20 volt setting.

If you're not sure, start with the highest setting.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.