Ga door naar hoofdinhoud

PowerBook G4 Aluminum 17" 1-1.67 GHz Upper Case Replacement

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 21 handleidingen die deze stap bevatten.

Engels
Nederlands
Stap 5
PowerBook G4 Aluminum 17" 1-1.67 GHz Upper Case Replacement: stap 0, afbeelding 1 van 1
  • For this step, you only need to move the connector about 2 mm. Pulling too hard or too far will damage the connector.

  • Loosen the trackpad connector by pulling the locking bar toward the battery housing, using the tips of your fingers.

  • Slide the trackpad cable out of the loosened connector.

  • When reattaching the trackpad ribbon cable, make sure that the orange cable is slid into the connector above the locking bar.

  • Note: When reassembling the case, the trackpad cable can get stuck below the slot to the motherboard. It's possible to nudge it out slowly by gently prodding it on either side with a small screwdriver. You don't need to use much force to do this. Eventually it will just pop back out and you can reconnect as per the instructions above. Also, note that the locking bar comes loose so if you see a little piece of plastic lying around when reassembling, that's what it is. :)

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Vertaling hier toevoegen

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.