Ga door naar hoofdinhoud
Help
Bewerken van stap 9 —

Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 25 handleidingen die deze stap bevatten.

Stap type:

Sleep om te herschikken

Place enough pressure on the upper case to allow you to slide a tool just within the seam between upper case and lower case as shown in the picture. A dentist's hook, push pin, or similar tool will work.

Do not yank the upper case off as soon as you free the clasp. The case is attached to the logic board via two ribbon cables.

Delicately slip the tip of your tool behind the silver metal latch and pull it forward while pulling up on the case. This may take some effort.

Alternatively, you can free the clasp with a small flathead screwdriver through the CD slot. The clasp is 1-3/16 in (3cm) from the left side of the slot. Use the screwdriver to lift out (or press back) the felt lining; then use the screwdriver to pull the clasp (shiny metal) forward to free it from the catch behind it (dull metal).

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.