Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Help
Bewerken van stap 1 —

Stap type:

Sleep om te herschikken

Turn the keyboard bezel around so that the touchpad is closer to you.

Disconnect the ribbon cable from the receptacle on the touchpad circuit board. The ribbon cable will not fall away because it is glued to the bracket that holds the touchpad in place

Remove the four 2.9mm screws from the bracket using a phillips PH0 screwdriver.

To remove the touchpad, simply push the touchpad from the top of the keyboard bezel (the touch-sensitive side, not circuit board side). This should require almost no force.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.