Waarschuwing: Je bewerkt een vooraf vereiste handleiding. Alle wijzigingen die je hierin maakt, beïnvloeden alle 7 handleidingen die deze stap bevatten.
Stap 1 vertalen
Stap 1
Remove motor assembly
-
Unscrew the two 5mm M4 phillips screws.
-
Unscrew the 7mm phillips screw.
-
Pull off the 25mm gear. (This usually allows the adjacent gear (green arrow, behind the outer bracket) to come off with the motor/ drive assembly; if it doesn't, this gear can be put back on afterwards).
-
Pull away the main drive motor/gear assembly from the printer to remove.
-
The 25mm drive gear (yellow arrow) and 30mm gear (orange arrow) can be replaced once the motor assembly is removed.
Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.