Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Help
Bewerken van stap 12 —

Stap type:

Sleep om te herschikken

If you see bulged capacitors, assume there is a residual charge.

If the filter capacitor is replaced, IT MUST BE DISCHARGED. In addition, the black screw (Blue) is a ground.

This capacitor is only found on older power supplies. Replacement is recommended, but not required.

With the power supply shield removed from the monitor, identify the power supply. Take note of the values, including the inverter cap if present.

Remove the 4 screws from the power supply. Once this is done, lift up the power supply at a slight angle to clear the chassis. Do not lift too much or the connector may be damaged!

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.