Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Onderdelen & Gereedschap

Help
Bewerken van stap 1 —

Stap type:

Sleep om te herschikken

One by one, de-solder the line of nine wires attached to the docking port board. After pulling out the wires, save them. This is done so that you can solder them into the new docking port board.

If you don't know how to solder, check out How To Solder and Desolder Connections.

Soldering irons are extremely hot and can burn you if you touch them!

If you hold the soldering iron tip at the same spot for too long, it can strip the metal from the plastic board. You may not be able to solder wire to that point again.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.