Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie


Bewerken van stap 1 —

Stap type:

Sleep om te herschikken

Using a Phillips #2 screwdriver, remove the two screws (circled in red) attaching the fan assembly to the unit.

Carefully disconnect the fan connector from the socket, as depicted in the second picture.

The controller connector panel can be gently pulled out of the main unit and laid down, as depicted. This is not strictly required, but may provide more maneuverability inside the case.

Make sure to not pull out the wires while removing the fan. Doing so may damage the connector wire or the PCB.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.