iMac Intel 27" 2012-2015 Adhesive Strips Replacement

Terug naar de handleiding

Engels

Nederlands

Vorige stap Volgende stap

Stap 16 vertalen

Stap 16

iMac Intel 27" 2012-2015 Adhesive Strips Replacement, Test your repair: stap 0, afbeelding 1 van 3

iMac Intel 27" 2012-2015 Adhesive Strips Replacement, Test your repair: stap 0, afbeelding 2 van 3

iMac Intel 27" 2012-2015 Adhesive Strips Replacement, Test your repair: stap 0, afbeelding 3 van 3

Test your repair

At this point it's a good idea to test your repair, in order to make sure your iMac works properly before you seal it back up. Follow the next three steps to temporarily reconnect the display cables and boot up your iMac prior to pulling the protective film off the adhesive strips.
If you've already verified that your iMac is working correctly and are ready to seal it up, skip to step 18.
Gently insert the display data connector into its socket on the logic board. Be sure to press it straight into the socket, and insert it completely.
Flip the display data connector lock down onto the socket.
Insert the display power connector into its socket on the logic board.

Je bijdragen zijn gelicentieerd onder de open source Creative Commons-licentie.