Ga door naar hoofdinhoud
Help
Bewerken van stap 2 —

Stap type:

Sleep om te herschikken

If the voltage is below about 2.75 volts, the battery will have to be removed. Using a soldering iron, melt the solder holding one of the solder tabs to the board. While the solder is molten, pull the solder tab away from the board with a pair of tweezers.

Repeat the procedure for the other solder tab.

The battery is held to the board with a piece of double sided fabric tape. This will probably rip apart when you pull the battery off.

It would be a good idea to put shrink tubing around the new battery to ensure it doesn't short out to anything on the control board.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.