Ga door naar hoofdinhoud

Repareer je spullen

Recht op reparatie

Winkel

Help
Bewerken van stap 6 —

Stap type:

Sleep om te herschikken

Use a 3 mm hexagonal wrench to release the heatsink. The wrench must be at least 15 cm long.

Release the holding bolts ONE TURN at a time, following an X pattern (top left, bottom right, top right, bottom left, far left) and continue until you hear a release click. Note: do not completely undo one bolt and then move to the next. Instead, repeat this patter, making one turn at a time, until the heatsink is released from the PCB.

When you replace the heatsink use the same pattern to tighten the bolts. Do not tighten more than finger tight. Make sure that the same tension is applied to each of the bolts. Uneven pressure can result in the CPU contacts failing. Symptoms range from boot-failure to missing or malfunctioning memory cards. 


Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.