Ga door naar hoofdinhoud
Help
Bewerken van stap 7 —

Waarschuwing: Je bewerkt nu een vooraf vereiste handleiding van de handleiding die je net bekeek. Alle wijzigingen die je hierin maakt, beïnvloeden alle 5 handleidingen die deze stap bevatten.

Stap type:

Sleep om te herschikken

Once you have sliced around the phone, twist an opening pick in one of the edges to help separate the back cover from the frame.

Lift the back cover slowly. Use opening picks to slice any remaining adhesive.

Remove the back cover.

Follow this guide to reinstall the back cover and replace the adhesive.

During reassembly, this is a good point to power on your phone and test all functions before you seal the back cover in place. Be sure to power your phone back down completely before you continue working.

If desired, you may reinstall the back cover without replacing the adhesive. Remove any large chunks of adhesive that might prevent the back cover from sitting down flush. After installation, heat the back cover and apply pressure to secure it. It won't be waterproof, but the glue is usually more than strong enough to hold.

Je bijdragen zijn gelicenseerd onder de open source Creative Commons licentie.